Sputtering Targets

26 Aug.,2024

 

Sputtering Targets

Sputtering Targets: Overview

About Sputtering Deposition

Sputtering deposition is one of the most common processes used for thin film deposition: the coating of a surface with a layer of material ranging from fractions of a nanometer to several micrometers in thickness. Thin film deposition is essential to manufacturing of many modern electronic and optical components

For more information, please visit our website.

Sputtering deposition uses a plasma, usually formed from a non-reactive gas, to bombard a target---a source of the material to be deposited as a thin film---and knock the atoms of the target material out of its bulk. The ejected atoms then land on the substrate and form a thin film. Since the target does not need to be heated, the technique is very flexible for a wide range of applications. Targets can be composed of pure elements as well as compounds or mixtures.

SEE STUDY

>

Types of Sputtering Targets

Standard Targets

Our standard target sizes range from 1" to 8" in diameter and from 2mm to 1/2" thick. We can also provide targets outside this range in addition to just about any size rectangular, annular, or oval-shaped target. Other shapes are available by request.

Acetron contains other products and information you need, so please check it out.

Rotatable Targets

For large area thin film deposition, American Elements produces rotatable sputtering targets via casting or plasma deposition onto a tubular substrate. Rotatable sputtering targets are available up to 1,000 mm in length and can be produced from a number of single element, oxide and alloy materials for use in many applications where large film areas are required, such as photovoltaic device fabrication. All machined pieces are produced by casting oversized blanks, and machining down to required specifications. They are usually machined to tolerances of +0.010"/-0" on diameter, length or width, and +/-0.005" on thickness. Larger targets are also finished to a flatness within 0.015". We can accommodate tighter tolerances upon request.

Rods and Plates

American Elements casts any of the rare earth metals and most other advanced material into rod, bar or plate form, as well as other machined shapes. All as-cast rods, bars and plates are produced from either the pure metal Ingots or sublimed metals. We have a variety of standard sized rod molds, from a minimum of 1/4" diameter up to 3" diameter for most rod needs. Plates are also offered in standard thicknesses, from 1/4" thick to 1" thick. Maximum rod lengths and maximum plate sizes are dependent on melt capacity and furnace room. Small diameter rods may have only a 4"-6" maximum cast length, whereas larger diameter rods may be cast up to about 16" long. Plate sizes can be cast up to a size of 24" x 16". As-cast rods or plates are saw-cut to length or final dimensions, and the metal surface may have visible flow marks.

Sputtering Targets

We provide one of the largest, most comprehensive lines of sputtering target materials. All popular geometries (and sizes) including rings, S-Guns and circular, rectangular and triangular and planar targets are available.

Most sputtering target materials can be fabricated into a wide range of shapes and sizes. There are some technical limitations to the maximum size for a given single piece construction. In such cases, a multi-segmented target can be produced with the individual segments joined together by butt or bevelled joints.

Please contact us if your required sputtering target material and/ or purity are not listed.